Skip to content 
Technical Guide: Riti Protocol Tracking Devices
The Riti protocol, typically operating on Port 5071, is a specialized communication standard used by high-performance GPS hardware like the SLS-00886, SLS-012SF, and TYN_886. These devices are designed for real-time fleet monitoring and asset security.
1. Hardware Comparison Table
| Model | Core Application | Battery | Standard Port |
|---|---|---|---|
| SLS-00886 | General Fleet Tracking | 3.7V 350mAh | 5071 |
| SLS-012SF | Slim/Secret Asset Tracking | 3.7V 180mAh | 5071 / 6071 |
| TYN_886 | Rugged Heavy Machinery | 3.7V 350mAh | 5071 |
2. Technical Wiring Diagrams
Proper installation requires connecting the 12-pin or 10-pin harness to the vehicle’s electrical system. Below is the standard color-coded wiring guide for Riti-compatible hardware.
Standard Wiring Pinout
- Red Wire: V+ Power (Connect to 12V or 24V DC battery)
- Black Wire: GND (Connect to vehicle chassis/Ground)
- White Wire: ACC / Ignition Sense (Detects when engine is running)
- Yellow Wire: Relay Control (Fuel/Engine Cut-off output)
- Green Wire: Door Trigger (Positive trigger)
- Blue Wire: Door Trigger (Negative trigger)
- Pink/Orange Wire: Siren/Horn output
Warning: Always use a fuse (3A-5A) on the Red power line. Disconnect vehicle power before wiring the relay to the Yellow line.
3. SMS Configuration Commands
To connect your device to a tracking server via the Riti protocol, send the following SMS commands from an authorized phone number. Note: Default password is usually 123456 or 000000.
A. Initialize the Device
Expected reply: “begin ok”
B. Set APN (Mobile Data Settings)
Replace “://operator.com” with your SIM provider’s APN.
C. Configure Server IP & Port (Port 5071)
Replace with your tracking platform’s IP address.
D. Set Tracking Intervals
This command sets the device to report every 30 seconds indefinitely.
4. Advanced Functions
- Authorize Number: Send
admin123456 [YourPhoneNumber]to set your phone as the master controller. - Check Status: Send
check123456to receive a report on battery level, GPS signal, and GPRS connection. - Fuel/Engine Cut: Send
stop123456to activate the relay;resume123456to restore power.
